Procedures for control of injection pressure procedures for control of injection pressure
The control of the injection pressure is usually divided into an injection pressure, the second injection pressure (holding pressure) or more than three times the injection pressure control. Switching time pressure if it is appropriate to prevent mold pressure is too high, to prevent overflow or lack of material are all very important. Mold packing stage the specific volume depends on the gate closed when the melt pressure and temperature. If the holding pressure time to switch to products from the cooling phase of the same pressure and temperature, then the specific volume of products will not change. Molding at a constant temperature to determine product size is the most important parameters of the packing pressure, affecting the product dimensional tolerances of the most important variable is the holding pressure and temperature. For example: after the end of the filling, packing pressure decreased immediately, when the surface to form a certain thickness, packing pressure to rise again, thus forming a low clamping force of large thick-walled products, elimination of collapse pits and flash.

Holding pressure and the speed is usually highest when the plastic cavity filling pressure and speed of 50% to 65%, which is holding pressure lower than the injection pressure of about 0.6 ~ 0.8MPa. As the packing pressure lower than the injection pressure, holding pressure in the considerable time, the pump load is low, solid pump life is extended, while oil pump motor power consumption is also reduced.

Three pressure injection filling both the smooth parts, and weld line does not appear, depression, flash and warpage. For thin-walled parts, small pieces of long, long process of molding large parts or even the cavity mold configuration is not balanced and not too close parts of the molding as a whole. the amount injected into the mold cavity filling process control of plastic
Regulate the use of certain measures in advance so near the end of the injection stroke, the screw end is still a small amount of residual melt (buffer capacity), according to the mold filling was further applied injection pressure (injection pressure two or three times) , add little melt. This can prevent depression or adjustment products product shrinkage. screw back pressure and speed of the process control
High back pressure can be intense shear melt at low speeds, will also get a long plastic tube in the machine plasticizing time. Therefore the current use of more back pressure and speed of parallel programming control. For example: measurement of the whole trip in the screw first high speed, low back pressure, and then switch to a lower speed, high back pressure, and then switch to high back pressure, low speed, and finally in the low back-pressure, low speed for plastics , so that the front screw melt most of the pressure be released, reducing the rotational inertia of the screw, thereby improving the accuracy of measurement of the screw. Often result in excessive back pressure increases the degree of stain color; pre-plastic bodies in increased mechanical wear screw and barrel; pre-plastic periodic extension of decline in production efficiency; nozzle prone to drooling, regeneration feeding amount increased; even with self-locking nozzle, if the back pressure higher than the design of the spring closure pressure may also cause fatigue failure. So, back pressure must be properly adjusted.
As technology advances, the small computer into the injection molding making machine control system, using a computer to control the injection molding process has become possible. Japan Steel Works N-PACS (micro-computer control system) can do four feedback control (holding pressure adjustment, molded adjustment, automatic measurement adjustment, resin temperature adjustment) and four process control (injection speed process control, pressure inspection, screw speed process control, process control back pressure).

From Website
Edited by Leafly Mould Provides Injection Mold, Plastic Mold, Injection Molding, Die Casting Mold, Stamping Mold

Related posts:

  1. The Importance of Precise Hot Runner Temperature Control