injection molding is the most commonly used plastic processing method. The method is applicable to all parts of thermoplastics and thermosetting plastics, plastic products obtained large quantities unmatched by other molding methods, injection molding process as one of the main tools for plastic injection molds, precision in quality, manufacturing cycle and injection molding process in the level of production efficiency, etc., directly affect the product quality, yield, cost and product updates, but also determines the competition in the market responsiveness and speed.
injection mold by a number of steel plates with the various component parts, and basically divided into:
A molding device (die, punch)
B positioning device (guide post, guide sleeve)
C fixtures (the word board, code-mode pits)
D cooling system (carrying water hole)
E constant temperature system (heat pipe, heater)
F flow system (pump nozzle holes and flow channel grooves, flow hole)
G top of the system (thimble, top stick)
5, the system according to the different type of gating system can mold into three categories:
(1) large outlet die: the flow channel and gate at the parting line, with products in the mold with the mold release time to design the most simple, easy processing, low cost, so the more people using a large nozzle system operation.
(2) fine nozzle mold: flow channel and the gate is not the parting line, usually directly on the product, so much to design a set of outlet parting line, the design is more complex, more difficult process, generally used depending on the product requirements fine nozzle system.
(3) hot runner mold: This mold structure and fine nozzle substantially the same, the biggest difference is that the flow in one or more of a constant temperature of the hot runner plate and heat pump mouth, no cold material ejection, and the water flow port directly on the product, so the flow does not require stripping, this system is also known as non-outlet system can save raw materials for more expensive raw materials, products require a higher situation, design and processing difficulties, mold costs are higher.
Hot runner systems, also known as the hot runner system, mainly by the hot sprue bush, hot runner plate, temperature control electric box composition. The most common hot runner hot runner system has a single point and multi-point thermal gate two forms. Single hot runner gate is a single set of heat directly to the molten plastic injected into the cavity, it applies to a single gate single cavity plastic mold; more hot runner hot runner plate through the molten material to each branch sub-set of the hot runner and then go to the cavity, it is more suitable for feeding a single cavity or multi-cavity mold.From Website
Edited by Leafly Mould Provides Injection Mold, Plastic Mold, Injection Molding, Die Casting Mold, Stamping Mold